Residential · St. Petersburg, FL
If your stucco weep screed is clogged, buried, rusted, or missing, moisture has nowhere to drain and the wall can trap water behind the finish. Superior Stucco St. Petersburg has served St. Petersburg since 2017, repairing weep screeds, kick-out flashing, and stucco-to-flashing transitions to restore proper drainage and code-style clearances.
We start by confirming where water is entering and where drainage is failing: low stucco-to-grade clearance, stucco packed into the weep holes, improper paper laps, or a termination that was never installed. After protecting landscaping and hardscapes, we saw-cut clean stucco edges, remove damaged basecoat and lath as needed, and inspect the bottom plate area for staining or soft sheathing. Repairs are rebuilt from the wall out, not just skimmed, using corrosion-resistant weep screed, galvanized or stainless fasteners where required, and proper laps with two layers of Grade D building paper or an approved WRB and self-adhered flashing tape at critical transitions.
Along the Gulf Coast, wind-driven rain, high humidity, and frequent irrigation overspray make the bottom of the wall a common failure zone, especially at lanais, pool decks, and planter edges. We set the screed to re-establish drainage and maintain a realistic clearance above soil, pavers, and concrete, then integrate it with step flashing, kick-out flashing, and door or window pan flashing so water exits at the exterior. Once the base is correct, we match your finish, including sand, dash, lace, or smooth stucco, and color-match paint or acrylic finish coat so the repair blends without telegraphing along the lower band.
St. Petersburg customers choose us because we treat stucco weep screed work as water-management construction, not cosmetic patching. Our crews are licensed and insured, and we bring the right tools for clean, controlled removals and consistent finishes, including diamond blades, HEPA dust control, corrosion-resistant lath accessories, and moisture checks when conditions warrant. You get clear scope, photos of what we find, and a written plan that addresses the cause, whether it is buried screed, missing flashing at roof-to-wall, or an incorrect termination at slab edges.
At completion, we walk the perimeter with you and verify the details that matter: visible, open screed holes, clean termination lines, sealed penetrations, and proper overlap where WRB and flashing tie into the screed. We document the repaired areas, note any recommended follow-up items (like grading, gutter discharge, or irrigation adjustments), and leave the site clean. You receive a free written estimate up front, a defined repair area, finish and color match options, and a drainage-focused repair that helps protect framing, sheathing, and interior finishes.
Yes. We provide a free written estimate after an on-site evaluation so the scope, materials, and repair method are clear.
Yes, we are licensed and insured for stucco work. Ask for documentation with your estimate.
Small repairs can take a day, while multi-elevation re-stucco can take several days to a few weeks depending on demo needs, curing time, weather, and access. We give a realistic schedule with your proposal.
Yes. We work on concrete block, CMU, and framed walls, adjusting lath, fasteners, and base-coat approach to suit the substrate and existing assembly.
When a permit is required for the scope, we coordinate the process and build to the applicable requirements. We will tell you upfront if permitting is likely.
A stucco weep screed is not decorative trim, it is the drainage and termination point at the bottom of a stucco wall. When it is missing, installed too low, rusted out, or packed with stucco and soil, water can stay trapped behind the cement plaster. Superior Stucco St. Petersburg repairs and replaces weep screeds and integrates the surrounding flashing details so moisture can exit the wall assembly the way it should.
Common warning signs include cracking along the lower 6-12 inches, dark staining after rain, peeling paint near slab edges, and soft or swollen trim at the base of the wall. In many cases, we find the stucco weep screed buried by mulch, pavers, or new concrete, or we see a screed installed without proper paper laps so water drains behind it instead of out through the holes. We also check roof-to-wall areas for missing kick-out flashing, and openings for improper pan flashing that can feed water down into the base of the stucco.
Our repair process focuses on building science basics: shingle-style overlaps, positive drainage, and corrosion resistance. We remove enough stucco to expose the failure point, replace damaged lath and accessories, and reinstall a code-style termination using a corrosion-resistant weep screed, proper fasteners, and compatible WRB and self-adhered flashing. After the scratch and brown coats cure, we texture-match the finish and provide paint or acrylic finish coat guidance so the bottom band blends cleanly.
If you are planning landscaping, paver work, or a repaint, it is a good time to confirm your stucco weep screed is visible and functional before problems show up inside. Contact Superior Stucco St. Petersburg for a free written estimate, and we will recommend the right repair scope for your walls, openings, and flashing transitions.
Call now or send a request and we will reach out within one business day to schedule your free, no-obligation estimate in St. Petersburg. We assess the project, review the details, and give you a written quote before any work starts, so you know exactly what to expect.
Prefer to write? Contact us or head back to the home page.
